search

Carlton 2518 Manuel de l'opérateur Page 103

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 199
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 102
18” DRUM SERVICE
CUTTER SYSTEM
76
• After the clearance has been set, tighten
the anvil bolts (1/2”-13) and torque to
75 ft. lbs.
• Retighten the nuts on the adjustment
bolts that were loosened earlier.
• Recheck the anvil/knife clearance to
make sure nothing changed when
tightening the bolts.
• Clearance should be .070” and .090”
(1.78 – 2.29 mm).
• ALWAYS REMEMBER TO CLOSE
THE CUTTER DRUM DOOR
AFTER SERVICING CUTTER
DRUM.
• INSTALL THE DOOR LOCK PIN
AND PADLOCK.
• Check condition of cutter drum door.
Make sure the hinges are not damaged
and that the door closes completely with
no gaps or openings; check both sides.
If there are any problems go to Servicing
Cutter Drum Door later in this section.
NO GAPS OR OPENINGS AROUND DOOR
Vue de la page 102
1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 198 199

Commentaires sur ces manuels

Pas de commentaire
  • Active Cool Dt-videolabs American Dynamics Adept technology CG Antenna
  • Amphony Cartes audio Air King Ventilateurs des ménages Hobart Lave-vaisselle Mission Subwoofers Nokia Casques d'écoute
  • Kicker ZX700.5 Excito B3 Brother MFC 6890CDW Rca 27F524T Samsung SGH-F480
  • Siemens GI38NP60 Manuel de l'utilisateur Yamaha NS-AW992 Spécifications Brother dcp 150c Manuel de l'utilisateur Yamaha Portatone PSR-540 Manuel du propriétaire Grizzly G0594 Manuel de l'utilisateur